Hurdles & Gates

1000mm high c/w drilled lugs at each end

1000mm High Opening of gate section is 835mm wide Gate has a top operated spring loaded slide bolt c/w hinged gate built into one end c/w drilled lugs at both end

Non Return Gate in Race Joining Arch. Base is drilled so that adjoining race hurdles can be tapered if required when working on lambs.

Part Meshed Lambing Hurdle can be used to form banks of single runs or back to back runs of lambing pens due to top loose ring and fixed 60mm x 60mm bottom lug type coupling arrangement Not compatible with standard 7 rail interlocking sheep hurdles 1050mm high with 5 horizontal rails and clad with 50mm x 50mm weldmesh up to a height of 524mm from finished floor level Approx Weight: 11kg

Pair of 6 rail sheep gates 1000mm high Gates are joined in the middle with a drop over frame Gates built into the frame C/w drilled lugs at each end

1000mm high c/w drilled lugs at each end

Sheep Swing Gate Built Into A Frame 1000mm high Gate has a top operated spring loaded slide bolt c/w drilled lugs at each end

Coupling Rod to Suit Cattle Hurdles is a walking stick type bar connects all hurdles to each other and to joining frames etc. Position of top lugs on hurdle enables coupling bar to eliminate potential leg trap between vertical end stiles of hurdles

Pin together for easy assembly (pin included) 7 horizontal rails with an overall height of 968 mm which allows for easy access to and from pens Internal venting for improved bio security All steelwork is hot dipped galvanised finish

Loop type coupling arrangement 970mm high The intended use for interlocking sheep hurdles is to form large holding pens or small individual pens. If used for long single runs of lambing pens or back to back lambing pens some joints will need to be cable tied together. Dimensions: 1220mm long x 970mm high x 50mm deep Approx Weight: 8.5kg

Mixed softwood lambing and general purpose sheep hurdle

Mixed softwood lambing and general purpose sheep hurdle